Remove Before Flight - Pásy 1:32 - 132052

Remove Before Flight

HGW models SEATBELTS in 1:32 scale

• microplastic sheeting, metallic buckles
• it is possible to make seat belts fully functional - un/buckle, un/fasten them
• made by special microplastic foil which is printed and behaves like a rag
• set contains seat belts for 2 single-seater aeroplanes
• microplastic parts are prepared to using filters - it leads to darkening shades - and these are also waterproofedand resistant to normal nonaggresive modeller preparations
• photo-etched parts were developed in cooperation with Eduard company

INSTRUCTIONS

This set contains printed and photoetched parts. Choose appropriate shade of belt and trim on dotted line using  very sharp knife. Trim to required length according to the type of seatbelt. Using fingers munch into little ball. Flatten out and thread through photoetched parts. Glue using white glue, do not use chemical glue that eches plastic. When applying, look at photos of cockpit of individual machines.  After glued and shaped, paint with matt varnish.